.32-20 Revolver

The place for general discussion about guns, gun (and gun parts) technology discussion, gun reviews, and gun specific range reports; and shooting, training, techniques, reviews and reports.
User avatar
PawPaw
Posts: 4493
Joined: Fri Jan 02, 2009 8:19 pm

.32-20 Revolver

Post by PawPaw »

My wife has a fondness for .32 caliber revolvers. Her dad had a fondness for .32 caliber revolvers and that carried over to her, for reasons I'll never understand. And, she likes the old Colt revolvers. She has extremely small hands, and finding a revolver to fit her (or modifying grips to fit her) is a challenge. However, the little Colts fit her just fine.

Couple of years ago, I found a Colt Pocket Positive in .32 SW Long and she carried it in her vehicle, shot it, really liked the little revolver. Unfortunately, in April we were traveling and the vehicle was burgled. They took the windshield mounted GPS and her little revolver. We were lucky that the burglars didn't look in the back seat, where more goodies (and more expensive goodies) were on the floorboards. Still, she mourned the loss of her revolver and I've been casting about for a replacement.

Yesterday I was passing through my favorite pawn shop and noticed a familiar profile in the case. A Colt Police Positive. I asked the counter-guy and he told me that it was a .32, more particularly, a .32-20 WCF, a cartridge with which I have no familiarity. But, I coon-fingered the revolver anyway. Blue steel with a tiny bit of surface wear near the muzzle, the little revolver looked pristine. I did a quick Jim March checkout and it passed with flying colors. In full lock the cylinder locked up tight as a bank vault. With the action relaxed, there was very little shake in the cylinder. The double-action pull stacked a bit toward the end of the travel, but broke cleanly. In single-action, the trigger seemed to break at about 4 lbs. It has the original grips, and the roll-marks are crisp and clean. The rampant colt on the left side plate is easily seen.

We dickered over the price and finally got down to $350.00, out the door. I asked for a 4473.

Image

I brought it home and before she arrived, I took out the bore light. The bore is also pristine. Nice clean rifling, no pitting, with a silvery sheen. The forcing cone is immaculate. A quick check with the Colt online site shows that this particular revolver was made in 1928. How it survived all those years with as little wear as it exhibits is a mystery. All I can figure is that grand-dad shot it once or twice then put it away. After the old man passed, the heirs decided that they'd rather have the money than the revolver. Seriously, it looks as if it spent the last 50-60 (maybe 70?) years in a desk drawer.

When my lady got home, I had stuck the little gun in my waistband and she didn't notice it. We poured a drink and retired to the veranda to discuss our day. I started telling her about the gun and I could tell that she was interested. The more I talked about it, the more interested she got. Then, I took it out of my waistband and handed it to her. She nearly hyperventilated

Now, I've got to find some .32-20 handgun ammo so she can shoot it. Luckily, it fits the El Paso Saddlery holster that I bought her for her other .32.
Dennis Dezendorf
PawPaw's House
User avatar
McClarkus
Posts: 802
Joined: Tue May 12, 2009 10:50 pm

Re: .32-20 Revolver

Post by McClarkus »

Good deal!
One secret to life. Step #1 - Find something you enjoy doing. Step #2 - Find someone foolish enough to pay you to do it.
User avatar
First Shirt
Posts: 4378
Joined: Mon Aug 18, 2008 11:32 pm

Re: .32-20 Revolver

Post by First Shirt »

The late Skeeter Skelton was a big fan of the .32-20, and wrote several good articles about ones that he'd owned, along with some load data for his favorites.

It's nice to see some of these old classics getting back in the game!
But there ain't many troubles that a man caint fix, with seven hundred dollars and a thirty ought six."
Lindy Cooper Wisdom
User avatar
Jered
Posts: 7859
Joined: Wed Aug 20, 2008 1:30 am

Re: .32-20 Revolver

Post by Jered »

I found a cold police positive in .38 Special. They're nice guns.
The avalanche has already started. It is too late for the pebbles to vote.
toad
Posts: 2645
Joined: Wed Aug 20, 2008 5:00 pm

Re: .32-20 Revolver

Post by toad »

I'd slug the barrel before I started doing reloads for it. .318 is typical. You can load it pretty hot depending on the firearm you are shooting it in. Velocities on the reloads run from about 1000 FPS to 1500 FPS. I think Winchester made a rifle in that caliber. With modern JHP bullets it can make some nasty holes IIRC.
User avatar
Netpackrat
Posts: 14002
Joined: Fri Aug 15, 2008 11:04 pm

Re: .32-20 Revolver

Post by Netpackrat »

Nice piece. Pretty sure I hate you.
Cognosce teipsum et disce pati

"People come and go in our lives, especially the online ones. Some leave a fond memory, and some a bad taste." -Aesop
User avatar
PawPaw
Posts: 4493
Joined: Fri Jan 02, 2009 8:19 pm

Re: .32-20 Revolver

Post by PawPaw »

toad wrote:I'd slug the barrel before I started doing reloads for it. .318 is typical. You can load it pretty hot depending on the firearm you are shooting it in. Velocities on the reloads run from about 1000 FPS to 1500 FPS. I think Winchester made a rifle in that caliber. With modern JHP bullets it can make some nasty holes IIRC.
I doubt seriously I'll reload for this caliber. I'll stick with factory ammo and probably stay down in Cowboy Action velocities. 800-850 fps should be sufficient to my purposes. Still, I'm amazed at how clean and pristine this little gun is.
Dennis Dezendorf
PawPaw's House
User avatar
Bob K
Posts: 1433
Joined: Tue Aug 19, 2008 2:03 pm

Re: .32-20 Revolver

Post by Bob K »

I've owned a couple .32-20 Colts over the years. Part of the reason these days I never sell or trade, only buy.

Originally chambered in the 1873 Winchester, along with .38-40 and .44-40, and carried over into the 1892. At one time, a hundred or so years ago, they were offered in both rifle and pistol loads. Never fire old rifle loads in a revolver.

Great caliber. Accurate, flat shooting, and with proper bullets does the job.
"Youth and skill are no match for age and treachery." Unknown

“A fear of weapons is a sign of retarded sexual and emotional maturity.” Sigmund Freud

"Oderint dum metuant." ("Let them hate, so long as they fear.") Accius
User avatar
First Shirt
Posts: 4378
Joined: Mon Aug 18, 2008 11:32 pm

Re: .32-20 Revolver

Post by First Shirt »

Somebody, some years ago, did a special-order run of Ruger Blackhawks with three cylinders: .32-20, .32 H&R Mag, and .30 carbine.

For my purposes, it would be about as useful as a steam-powered stapler, but it sure tripped the "Nifty gadget" meter.
But there ain't many troubles that a man caint fix, with seven hundred dollars and a thirty ought six."
Lindy Cooper Wisdom
User avatar
Cybrludite
Posts: 5048
Joined: Fri Aug 15, 2008 9:13 am

Re: .32-20 Revolver

Post by Cybrludite »

"If it ain't the Devil's Music, you ain't doin' it right." - Chris Thomas King

"When liberal democracies collapse, someone comes along who promises to make the trains run on time if we load the right people into them." - Tam K.
Post Reply