Decisions, Decisions

[PawPaw]

I already have a castle nut wrench,a nd believe it or not, a handguard removal tool (although for the life of me, I can't remember why. I've never needed a tool to remove the handguards n an AR). So, I'm going to need some punches, an action block, and a few other odds and ends.

OH, those lowers are still on sale, if y'all are interested.

[Flintlock Tom]

Unfortunately those are particularly evil receivers and cannot be shipped to California. Further evidence, if any was needed, that the CA legislature rides to work on the Short Bus.

[Jered]

I used the handle of a ratchet to pound in the magazine release roll pin on my last AR build. It worked better than the soft hammer and a punch.

The only tool I've found that is absolutely required is a castle nut wrench.